Ontario AZ Licence Practice Test 2026: Teste prático 5

Teste prático 5 de 6 — Ontario AZ Licence Practice Test: mais 25 perguntas com respostas e explicações.

Veículo pesado
Ontário
150 perguntas
Verificado em 10 de outubro de 2026

Pergunta 1 de 25
Which brake chamber size is the most common?
- Type 30
- Type 12
- Type 36
- Type 6
Mostrar resposta
Resposta: A. Type 30
The handbook notes that size 30 is the most common chamber.
Pergunta 2 de 25
What do the brake chambers do?
- Remove water and oil from the compressed air
- Turn air pressure into force on the push rod
- Store extra air for the horn and the seats
- Cool the brakes by blowing air on the drums
Mostrar resposta
Resposta: B. Turn air pressure into force on the push rod
Air enters the chamber and pushes a diaphragm, which moves the push rod.
Pergunta 3 de 25
The low air warning comes on while you are driving. What should you do?
- Stop safely as soon as possible and find the cause
- Close the trailer supply valve and speed up
- Keep driving to the next terminal
- Pump the brake pedal to build pressure
Mostrar resposta
Resposta: A. Stop safely as soon as possible and find the cause
Low pressure means you are losing braking power and spring brakes may soon apply. Stop safely and find the problem.
Pergunta 4 de 25
During the mechanical inspection, what do you check on the air compressor?
- The tire pressure on the nearest wheel
- The drive belt condition and tension, and the mounting
- The fuel level and the oil in the fuel tank
- The colour of the paint and the make of the compressor
Mostrar resposta
Resposta: B. The drive belt condition and tension, and the mounting
Check the compressor's belt, pulley, mounting, brackets and fasteners.
Pergunta 5 de 25
An automatic slack adjuster keeps needing to be re-adjusted. What does that mean?
- It is working normally
- The governor is set too high
- There is a defect that must be repaired
- The tires are under-inflated
Mostrar resposta
Resposta: C. There is a defect that must be repaired
Frequent re-adjustment of an automatic slack adjuster points to a defect in the brake.
Pergunta 6 de 25
What are the service brakes used for?
- Parking overnight only
- Emergency stops only
- Holding the trailer while coupling only
- Normal stopping, applied with the brake pedal
Mostrar resposta
Resposta: D. Normal stopping, applied with the brake pedal
Service brakes are the brakes you use for normal stops, applied with the pedal.
Pergunta 7 de 25
When is a brake considered out of adjustment?
- When applied push rod stroke is over the limit for that chamber
- When the push rod moves at all during a brake application
- When the drum feels warm after a short drive
- When the brake makes no noise as it applies
Mostrar resposta
Resposta: A. When applied push rod stroke is over the limit for that chamber
Any push rod stroke over the chamber's adjustment limit means the brake is defective.
Pergunta 8 de 25
Which tests must you pass at DriveTest to get the Z endorsement?
- Only a road test in traffic with air brakes
- Only a vision test and a medical review
- A medical exam and a hearing test
- An air brake knowledge test and a practical test
Mostrar resposta
Resposta: D. An air brake knowledge test and a practical test
You pass the air brake knowledge test and then book and pass the practical test.
Pergunta 9 de 25
What is the job of the tractor protection valve?
- To keep the tractor's air if the trailer is disconnected or breaks away
- To control the trailer's lights and turn signals
- To measure the trailer's weight before you drive
- To protect the tractor's paint from stones thrown by the trailer
Mostrar resposta
Resposta: A. To keep the tractor's air if the trailer is disconnected or breaks away
The tractor protection valve prevents air loss from the towing vehicle when no trailer is attached or the trailer lines fail.
Pergunta 10 de 25
What is the adjustment limit for a standard type 24 chamber?
- 35 mm (1-3/8 inches)
- 57 mm (2-1/4 inches)
- 45 mm (1-3/4 inches)
- 64 mm (2-1/2 inches)
Mostrar resposta
Resposta: C. 45 mm (1-3/4 inches)
A standard type 24 chamber has a 45 mm (1-3/4 inch) limit.
Pergunta 11 de 25
Gladhands connect the air lines between tractor and trailer. Which colour is the supply (emergency) line?
- Red
- Black
- Blue
- Green
Mostrar resposta
Resposta: A. Red
Red gladhands are for the supply (emergency) line and blue are for the service line.
Pergunta 12 de 25
Which situation is most likely to cause severe brake fade?
- Using the engine brake on a short hill with an empty trailer
- A long downhill run with a heavy load at too high a speed
- Parking overnight in very cold weather with the spring brakes on
- Driving slowly on a flat road in town with many stops
Mostrar resposta
Resposta: B. A long downhill run with a heavy load at too high a speed
Long descents, overloading and too much speed can overheat the brakes so badly that you cannot stop.
Pergunta 13 de 25
What does the one-way check valve do?
- Stops air from flowing back out of a tank
- Lets air flow both ways freely
- Releases air when pressure is high
- Applies the parking brake
Mostrar resposta
Resposta: A. Stops air from flowing back out of a tank
A one-way check valve lets air into a tank but prevents it from flowing back out.
Pergunta 14 de 25
Why is the supply tank called the wet tank?
- It collects most of the moisture and oil from the compressed air
- It is mounted under the fuel tank and gets wet in rain
- It is filled with water on purpose to cool the air
- It holds the windshield washer fluid for the cab
Mostrar resposta
Resposta: A. It collects most of the moisture and oil from the compressed air
The supply tank receives air first and collects most of the moisture and oil.
Pergunta 15 de 25
In the air-loss test, what is the most pressure a tractor and one trailer may lose in one minute?
- 41 kPa (6 psi)
- 14 kPa (2 psi)
- 55 kPa (8 psi)
- 28 kPa (4 psi)
Mostrar resposta
Resposta: D. 28 kPa (4 psi)
A tractor and trailer may lose no more than 28 kPa (4 psi) per minute.
Pergunta 16 de 25
What is the lowest allowed governor cut-in pressure?
- 414 kPa (60 psi)
- 690 kPa (100 psi)
- 380 kPa (55 psi)
- 552 kPa (80 psi)
Mostrar resposta
Resposta: D. 552 kPa (80 psi)
The cut-in pressure must not be below 552 kPa (80 psi).
Pergunta 17 de 25
What does it mean if a spring brake chamber is caged?
- It has been filled with oil to stop it from rusting
- It is locked so no one can steal the brake parts
- It has a metal cover to keep out snow and road salt
- Its spring is held back by a caging bolt, so it will not apply
Mostrar resposta
Resposta: D. Its spring is held back by a caging bolt, so it will not apply
A technician can cage the spring with a bolt, for example to move a vehicle in an emergency. The protruding bolt shows it is caged.
Pergunta 18 de 25
Who may adjust manual slack adjusters?
- Only certified technicians
- Anyone with a wrench
- Any driver with a Z endorsement
- Any passenger
Mostrar resposta
Resposta: A. Only certified technicians
Only certified technicians may adjust manual slack adjusters. Drivers should not try to repair automatic adjusters.
Pergunta 19 de 25
What is an alcohol evaporator for?
- To add alcohol vapour to the air and reduce freezing in the system
- To test the driver's breath for alcohol before starting
- To cool the engine on long, steep hills
- To clean the windshield in freezing weather
Mostrar resposta
Resposta: A. To add alcohol vapour to the air and reduce freezing in the system
An alcohol evaporator puts alcohol vapour into the air to help stop moisture freezing in the lines and valves.
Pergunta 20 de 25
What must Z-endorsed drivers aged 80 or older do every year?
- Take a full road test only, with no air brake check
- Retake the full air brake course with a fleet owner
- Nothing extra; renewal is every 5 years as usual
- Complete the online module and an air brake practical test
Mostrar resposta
Resposta: D. Complete the online module and an air brake practical test
At 80 and older, you must complete the online module and practical test every year.
Pergunta 21 de 25
Why should you never try to take apart a spring brake chamber?
- The spring is under very high tension and can injure you
- Opening it voids the trailer's registration
- It is full of hot oil that can burn your hands
- It contains a sensor that records brake use
Mostrar resposta
Resposta: A. The spring is under very high tension and can injure you
The spring in the chamber is under very high tension. Never try to service or repair it.
Pergunta 22 de 25
What is a slack adjuster?
- A lever that links the push rod to the brake camshaft
- A spring inside the chamber that holds the parking brake
- A gauge on the dashboard that shows brake wear
- A valve that lets out extra air when pressure is too high
Mostrar resposta
Resposta: A. A lever that links the push rod to the brake camshaft
The slack adjuster connects the push rod to the camshaft and increases the braking force.
Pergunta 23 de 25
In the air-loss test, what is the most pressure a straight truck, tractor or bus may lose in one minute?
- 21 kPa (3 psi)
- 69 kPa (10 psi)
- 41 kPa (6 psi)
- 7 kPa (1 psi)
Mostrar resposta
Resposta: A. 21 kPa (3 psi)
A single vehicle may lose no more than 21 kPa (3 psi) per minute.
Pergunta 24 de 25
What does the letter L stamped on a brake chamber cover mean?
- It is a long-stroke chamber, with a longer adjustment limit
- It is a left-side chamber
- It is a low-pressure chamber
- It is a light-duty chamber that is not allowed on trucks
Mostrar resposta
Resposta: A. It is a long-stroke chamber, with a longer adjustment limit
L marks a long-stroke design. Long-stroke chambers have longer adjustment limits than standard ones.
Pergunta 25 de 25
After your air brake course, you receive a referral envelope. Within how long must you take it to a DriveTest centre?
- 1 year
- 6 months
- 30 days
- 2 years
Mostrar resposta
Resposta: B. 6 months
Take the referral envelope to a DriveTest centre within 6 months.

Testes relacionados