Ontario AZ Licence Practice Test 2026: Test próbny 4

Test próbny 4 z 6 – Ontario AZ Licence Practice Test: kolejne pytania z odpowiedziami i wyjaśnieniami (liczba pytań: 25).

  • Pojazdy ciężarowe
  • Ontario
  • Pytania: 150
  • Sprawdzono 10 października 2026
  1. Pytanie 1 z 25

    What applies the spring brakes?
    Pokaż odpowiedź

    Odpowiedź: B. A large spring, which air pressure holds back

    Spring brakes are applied by a strong spring and released by air pressure, so they apply when air is lost.

  2. Pytanie 2 z 25

    The low air pressure warning must come on before pressure drops below what level?
    Pokaż odpowiedź

    Odpowiedź: B. 380 kPa (55 psi)

    The warning is defective if it does not activate or if it activates below 380 kPa (55 psi). Most activate at 414 kPa (60 psi) or higher.

  3. Pytanie 3 z 25

    What is the adjustment limit for a type 30 long-stroke chamber?
    Pokaż odpowiedź

    Odpowiedź: A. 64 mm (2-1/2 inches)

    A type 30 long-stroke chamber (with square ports and stroke markings) has a 64 mm (2-1/2 inch) limit.

  4. Pytanie 4 z 25

    How often should you check the push rod stroke (brake adjustment)?
    Pokaż odpowiedź

    Odpowiedź: A. At least daily

    The handbook says brake adjustment should be checked at least daily.

  5. Pytanie 5 z 25

    What helps reduce brake heat on long downgrades?
    Pokaż odpowiedź

    Odpowiedź: C. Using an engine brake or retarder

    Engine brakes and retarders slow the vehicle without heating the service brakes.

  6. Pytanie 6 z 25

    How do you know the tractor protection valve is defective during the test?
    Pokaż odpowiedź

    Odpowiedź: B. Air exhausts from the trailer service line when you press the pedal

    With the trailer supply closed, pressing the pedal should not send air out of the trailer service line.

  7. Pytanie 7 z 25

    When draining the air tanks at the end of the pre-trip check, which tank do you drain first?
    Pokaż odpowiedź

    Odpowiedź: C. The supply (wet) tank

    Drain the supply tank first, because it collects most of the water and oil, then check each drain valve.

  8. Pytanie 8 z 25

    In the air brake practical exam, which brake adjustment method must you demonstrate?
    Pokaż odpowiedź

    Odpowiedź: B. The applied push rod stroke measurement method

    Candidates must show the applied method of measuring push rod stroke.

  9. Pytanie 9 z 25

    Which item must you bring to the air brake practical test?
    Pokaż odpowiedź

    Odpowiedź: A. Wheel chocks and a watch or stopwatch with a second hand

    Bring wheel chocks, a timing device, a way to hold the brake pedal down and tools to mark and measure push rod stroke.

  10. Pytanie 10 z 25

    What does the air dryer do?
    Pokaż odpowiedź

    Odpowiedź: B. Removes moisture before air enters the supply tank

    The air dryer removes moisture before the air reaches the supply tank.

  11. Pytanie 11 z 25

    If you double both your weight and your speed, how much longer is the stopping distance?
    Pokaż odpowiedź

    Odpowiedź: C. Eight times longer

    Doubling both weight and speed makes the stopping distance eight times longer.

  12. Pytanie 12 z 25

    What is the first step to get a Z endorsement in Ontario?
    Pokaż odpowiedź

    Odpowiedź: A. Take an air brake endorsement course from an approved provider

    You first take an air brake course from a fleet owner, community college or safety organization.

  13. Pytanie 13 z 25

    What is the adjustment limit for a standard type 30 clamp-type brake chamber?
    Pokaż odpowiedź

    Odpowiedź: C. 51 mm (2 inches)

    A standard type 30 chamber has an adjustment limit of 51 mm (2 inches).

  14. Pytanie 14 z 25

    As air pressure drops, in what range does the trailer supply valve close by itself?
    Pokaż odpowiedź

    Odpowiedź: C. 138 to 311 kPa (20 to 45 psi)

    The trailer supply valve pops out automatically between 138 and 311 kPa (20 and 45 psi).

  15. Pytanie 15 z 25

    You find an air brake defect during your inspection. What does Ontario law say about driving the vehicle?
    Pokaż odpowiedź

    Odpowiedź: A. It is illegal to drive a defective vehicle, and you must report the defect

    Drivers must report defects, and it is illegal to drive a defective vehicle.

  16. Pytanie 16 z 25

    How long do you watch the gauge during the air-loss rate test?
    Pokaż odpowiedź

    Odpowiedź: C. 1 minute

    The air-loss test measures the pressure drop over one minute.

  17. Pytanie 17 z 25

    What makes an air tank defective in the mechanical inspection?
    Pokaż odpowiedź

    Odpowiedź: A. It is not securely mounted

    Air tanks must be securely mounted.

  18. Pytanie 18 z 25

    What are foundation brakes?
    Pokaż odpowiedź

    Odpowiedź: A. The brake parts at each wheel, such as drums and shoes

    Foundation brakes are the wheel-mounted parts, such as drums or rotors and shoes or pads, worked by the air system.

  19. Pytanie 19 z 25

    At about what pressure does the supply tank safety valve normally open?
    Pokaż odpowiedź

    Odpowiedź: D. 1035 kPa (150 psi)

    The safety valve protects the system from too much pressure. It normally opens at 1035 kPa (150 psi).

  20. Pytanie 20 z 25

    During the build-up test, how long may it take for pressure to rise from 587 to 690 kPa (85 to 100 psi) at 600 to 900 rpm?
    Pokaż odpowiedź

    Odpowiedź: B. No more than 2 minutes

    If build-up from 587 to 690 kPa takes more than two minutes, the system is defective.

  21. Pytanie 21 z 25

    How do you test the spring (parking) brakes' holding ability?
    Pokaż odpowiedź

    Odpowiedź: A. With them applied, gently apply engine power and see if they hold

    The spring brakes are defective if they do not hold the vehicle still when engine power is applied gently.

  22. Pytanie 22 z 25

    Which brake drum condition is a defect?
    Pokaż odpowiedź

    Odpowiedź: A. A crack or break in the drum

    Inspect brake drums or rotors for cracks or breaks.

  23. Pytanie 23 z 25

    According to the Ontario handbook, what is the highest allowed governor cut-out pressure?
    Pokaż odpowiedź

    Odpowiedź: C. 1000 kPa (145 psi)

    The cut-out pressure must not be above 1000 kPa (145 psi).

  24. Pytanie 24 z 25

    What is the difference between version 1 and version 2 of the air brake practical test?
    Pokaż odpowiedź

    Odpowiedź: D. Version 1 is for tractor-trailer air systems; version 2 is for other vehicles

    Version 1 covers vehicles with a tractor-trailer air brake system; version 2 covers vehicles without that system.

  25. Pytanie 25 z 25

    In Ontario, which vehicles need a Z endorsement on your licence?
    Pokaż odpowiedź

    Odpowiedź: B. Vehicles with air brakes or air-over-hydraulic brakes

    You need a Z endorsement to drive any vehicle with air brakes or air-over-hydraulic brakes.

Powiązane testy