Ontario AZ Licence Practice Test 2026: Quiz di prova 4
Quiz di prova 4 di 6 per Ontario AZ Licence Practice Test: altre 25 domande con risposte e spiegazioni.
-
Domanda 1 di 25
Mostra la risposta
Risposta: B. A large spring, which air pressure holds back
Spring brakes are applied by a strong spring and released by air pressure, so they apply when air is lost.
-
Domanda 2 di 25
Mostra la risposta
Risposta: B. 380 kPa (55 psi)
The warning is defective if it does not activate or if it activates below 380 kPa (55 psi). Most activate at 414 kPa (60 psi) or higher.
-
Domanda 3 di 25
Mostra la risposta
Risposta: A. 64 mm (2-1/2 inches)
A type 30 long-stroke chamber (with square ports and stroke markings) has a 64 mm (2-1/2 inch) limit.
-
Domanda 4 di 25
Mostra la risposta
Risposta: A. At least daily
The handbook says brake adjustment should be checked at least daily.
-
Domanda 5 di 25
Mostra la risposta
Risposta: C. Using an engine brake or retarder
Engine brakes and retarders slow the vehicle without heating the service brakes.
-
Domanda 6 di 25
Mostra la risposta
Risposta: B. Air exhausts from the trailer service line when you press the pedal
With the trailer supply closed, pressing the pedal should not send air out of the trailer service line.
-
Domanda 7 di 25
Mostra la risposta
Risposta: C. The supply (wet) tank
Drain the supply tank first, because it collects most of the water and oil, then check each drain valve.
-
Domanda 8 di 25
Mostra la risposta
Risposta: B. The applied push rod stroke measurement method
Candidates must show the applied method of measuring push rod stroke.
-
Domanda 9 di 25
Mostra la risposta
Risposta: A. Wheel chocks and a watch or stopwatch with a second hand
Bring wheel chocks, a timing device, a way to hold the brake pedal down and tools to mark and measure push rod stroke.
-
Domanda 10 di 25
Mostra la risposta
Risposta: B. Removes moisture before air enters the supply tank
The air dryer removes moisture before the air reaches the supply tank.
-
Domanda 11 di 25
Mostra la risposta
Risposta: C. Eight times longer
Doubling both weight and speed makes the stopping distance eight times longer.
-
Domanda 12 di 25
Mostra la risposta
Risposta: A. Take an air brake endorsement course from an approved provider
You first take an air brake course from a fleet owner, community college or safety organization.
-
Domanda 13 di 25
Mostra la risposta
Risposta: C. 51 mm (2 inches)
A standard type 30 chamber has an adjustment limit of 51 mm (2 inches).
-
Domanda 14 di 25
Mostra la risposta
Risposta: C. 138 to 311 kPa (20 to 45 psi)
The trailer supply valve pops out automatically between 138 and 311 kPa (20 and 45 psi).
-
Domanda 15 di 25
Mostra la risposta
Risposta: A. It is illegal to drive a defective vehicle, and you must report the defect
Drivers must report defects, and it is illegal to drive a defective vehicle.
-
Domanda 16 di 25
Mostra la risposta
Risposta: C. 1 minute
The air-loss test measures the pressure drop over one minute.
-
Domanda 17 di 25
Mostra la risposta
Risposta: A. It is not securely mounted
Air tanks must be securely mounted.
-
Domanda 18 di 25
Mostra la risposta
Risposta: A. The brake parts at each wheel, such as drums and shoes
Foundation brakes are the wheel-mounted parts, such as drums or rotors and shoes or pads, worked by the air system.
-
Domanda 19 di 25
Mostra la risposta
Risposta: D. 1035 kPa (150 psi)
The safety valve protects the system from too much pressure. It normally opens at 1035 kPa (150 psi).
-
Domanda 20 di 25
Mostra la risposta
Risposta: B. No more than 2 minutes
If build-up from 587 to 690 kPa takes more than two minutes, the system is defective.
-
Domanda 21 di 25
Mostra la risposta
Risposta: A. With them applied, gently apply engine power and see if they hold
The spring brakes are defective if they do not hold the vehicle still when engine power is applied gently.
-
Domanda 22 di 25
Mostra la risposta
Risposta: A. A crack or break in the drum
Inspect brake drums or rotors for cracks or breaks.
-
Domanda 23 di 25
Mostra la risposta
Risposta: C. 1000 kPa (145 psi)
The cut-out pressure must not be above 1000 kPa (145 psi).
-
Domanda 24 di 25
Mostra la risposta
Risposta: D. Version 1 is for tractor-trailer air systems; version 2 is for other vehicles
Version 1 covers vehicles with a tractor-trailer air brake system; version 2 covers vehicles without that system.
-
Domanda 25 di 25
Mostra la risposta
Risposta: B. Vehicles with air brakes or air-over-hydraulic brakes
You need a Z endorsement to drive any vehicle with air brakes or air-over-hydraulic brakes.
Tastiera: 1–4 per rispondere, Invio per la domanda successiva.