B.C. Class 1 Knowledge Practice Test 2026: Oefenexamen 4

Oefenexamen 4 van 5 voor B.C. Class 1 Knowledge Practice Test: 25 extra vragen met antwoorden en uitleg.

Bedrijfsvoertuig
Brits-Columbia
130 vragen
Gecontroleerd op 10 oktober 2026

Vraag 1 van 25
In this air brake diagram, what is the job of the air compressor?
- To remove water from the tanks
- To pump air into the storage tanks
- To measure push rod stroke
- To apply the parking brake
Toon antwoord
Antwoord: B. To pump air into the storage tanks
The engine-driven compressor pumps air into the tanks.
Vraag 2 van 25
Since April 1, 2000, which trailers must have anti-lock brakes in Canada?
- Only trailers under 1,000 kg
- No trailers; only the tractor needs it
- Only boat and recreational trailers
- Commercial trailers with air brakes
Toon antwoord
Antwoord: D. Commercial trailers with air brakes
ABS is mandatory on commercial trailers with air brakes, and on trucks and buses over 4,560 kg built since April 1, 2000.
Vraag 3 van 25
Why do you check for air leaks with the brakes applied?
- Leaks drain air quickly just when you need the brakes
- To test that the horn works on air
- To warm up the engine before driving
- To check the tire pressure on each wheel
Toon antwoord
Antwoord: A. Leaks drain air quickly just when you need the brakes
Leaks reduce the air available for braking, and they get worse when the system is under pressure.
Vraag 4 van 25
Why are spring brakes used for parking?
- They are the only brakes fitted to the trailer
- They hold mechanically, without needing air in the system
- They are stronger only while the engine runs
- They use less fuel than the service brakes
Toon antwoord
Antwoord: B. They hold mechanically, without needing air in the system
Service brakes rely on air pressure, which can leak away. Spring brakes hold with spring force.
Vraag 5 van 25
Before you drive, the air gauge shows low pressure. What should you do?
- Drive off and let it build while moving
- Drain the tanks and start again
- Let the pressure build to normal before moving
- Release the spring brakes by hand
Toon antwoord
Antwoord: C. Let the pressure build to normal before moving
Do not move until the air pressure has built up and the low air warning has gone off.
Vraag 6 van 25
Why does air brake lag matter for following distance?
- It adds distance before the brakes work, so you need a bigger gap
- It only matters when the vehicle is parked
- It lets you follow more closely than a car
- It makes the brakes work instantly, so gaps can be small
Toon antwoord
Antwoord: A. It adds distance before the brakes work, so you need a bigger gap
Lag time is added to perception and reaction time, so the truck travels further before braking starts.
Vraag 7 van 25
What does too much push rod stroke mean?
- The brake is working perfectly
- The governor is set too low
- The brake is out of adjustment
- The tank is too full
Toon antwoord
Antwoord: C. The brake is out of adjustment
Excess push rod travel means the brake is out of adjustment and will not give full braking force.
Vraag 8 van 25
What does the parking brake control knob usually look like?
- A green toggle switch
- A blue, square lever
- A yellow, diamond-shaped push-pull knob
- A red, round push button
Toon antwoord
Antwoord: C. A yellow, diamond-shaped push-pull knob
The parking (spring) brake control is a yellow, diamond-shaped push-pull knob.
Vraag 9 van 25
During an air brake check, what should happen when you reduce the air pressure by fanning the brakes?
- The engine should stop when pressure falls
- The spring brakes should apply before the warning comes on
- The low air warning should come on before the spring brakes apply
- Nothing should happen until the tanks are empty
Toon antwoord
Antwoord: C. The low air warning should come on before the spring brakes apply
The warning must activate before pressure falls low enough for the spring brakes to apply.
Vraag 10 van 25
Why should you avoid fanning (pumping) air brakes?
- It wastes air and lowers the pressure in the system
- It drains fuel from the tank
- It makes the brakes far too strong
- It overheats the engine and compressor
Toon antwoord
Antwoord: A. It wastes air and lowers the pressure in the system
Each pump uses air. Fanning the brakes can drop pressure quickly.
Vraag 11 van 25
A truck has 16 brakes and one is out of adjustment. What happens?
- The truck stops faster than before
- The air compressor stops pumping
- Nothing; one brake out of 16 does not matter
- The other brakes must do more of the work
Toon antwoord
Antwoord: D. The other brakes must do more of the work
Each brake is designed to do its share. If one is out of adjustment, the others work harder and may overheat.
Vraag 12 van 25
Why must water be drained from air tanks?
- Water can freeze and block valves and lines
- Water makes the brakes stronger
- Water cools the engine
- Water is needed for the brakes to work
Toon antwoord
Antwoord: A. Water can freeze and block valves and lines
Water and oil collect in the tanks. In cold weather, water can freeze and stop the system working.
Vraag 13 van 25
About how much time does air brake lag add before the brakes begin to apply?
- About four-tenths of a second
- About 4 seconds
- About 1 full minute
- No time at all
Toon antwoord
Antwoord: A. About four-tenths of a second
Air brake lag time is about 4/10 of a second.
Vraag 14 van 25
For how long is a passed air brake knowledge test result valid in B.C.?
- For life
- Five years
- One year
- One month
Toon antwoord
Antwoord: C. One year
The air brake knowledge test result is valid for one year.
Vraag 15 van 25
What should you check on the compressor during the air brake inspection?
- The colour and make of the compressor
- That a belt-driven compressor's belt is in good shape and tight
- The fuel level inside the compressor
- The compressor's radio and wiring connection
Toon antwoord
Antwoord: B. That a belt-driven compressor's belt is in good shape and tight
A loose or worn belt can stop the compressor from building air.
Vraag 16 van 25
Where do you apply to take the air brake knowledge test in B.C.?
- At your trucking company
- At a police station
- At a driver licensing office
- At a weigh scale
Toon antwoord
Antwoord: C. At a driver licensing office
Apply at a driver licensing office with your ID and pay the knowledge test fee.
Vraag 17 van 25
How is brake adjustment checked on S-cam brakes?
- By listening to the brakes while driving slowly
- By checking the tire pressure on each axle
- By measuring push rod stroke with the brakes fully applied
- By feeling how hot each drum is after a trip
Toon antwoord
Antwoord: C. By measuring push rod stroke with the brakes fully applied
Measure how far the push rod moves on a full application. Too much stroke means the brake is out of adjustment.
Vraag 18 van 25
Is a road test required for the air brake endorsement in B.C.?
- Yes, in a tractor-trailer
- No
- Yes, but only at night
- Yes, in a bus
Toon antwoord
Antwoord: B. No
The air brake endorsement needs a knowledge test and a pre-trip inspection test, but no road test.
Vraag 19 van 25
When air enters a brake chamber, what moves?
- A diaphragm pushes the push rod out
- The brake drum starts to spin faster
- The governor cuts out the compressor
- The tank drain valve opens
Toon antwoord
Antwoord: A. A diaphragm pushes the push rod out
Air pressure pushes the diaphragm, which pushes the rod that turns the slack adjuster.
Vraag 20 van 25
How does a retarder help the air brakes?
- It adds extra air to the tanks while you drive
- It makes the service brakes apply faster
- It adjusts the slack adjusters automatically
- It slows you without the service brakes, so they stay cool
Toon antwoord
Antwoord: D. It slows you without the service brakes, so they stay cool
Retarders such as engine and exhaust brakes reduce the work, heat and wear on the service brakes.
Vraag 21 van 25
What is the possible fine for brakes that are not correctly adjusted?
- Up to $20
- Up to $100
- Up to $2,000
- No fine, only a warning
Toon antwoord
Antwoord: C. Up to $2,000
Brakes not adjusted or not performing properly can bring a fine of up to $2,000.
Vraag 22 van 25
Which part senses tank pressure and controls the compressor?
- The slack adjuster
- The governor
- The brake chamber
- The brake drum
Toon antwoord
Antwoord: B. The governor
The governor tells the compressor when to stop (cut out) and start (cut in) pumping.
Vraag 23 van 25
On a Class 1 road test in a vehicle with air brakes, which inspection is included?
- A full engine inspection
- A tire change on the trailer
- An air brake pre-trip inspection
- A fuel economy check
Toon antwoord
Antwoord: C. An air brake pre-trip inspection
Road tests include an air brake pre-trip inspection when the vehicle has air brakes.
Vraag 24 van 25
What connects the push rod to the brake camshaft?
- The gladhand
- The foot valve
- The slack adjuster
- The governor
Toon antwoord
Antwoord: C. The slack adjuster
The slack adjuster links the push rod to the camshaft and adds leverage.
Vraag 25 van 25
What temperature should brake parts not go above?
- About 900 °C
- About 60 °C
- About 250 °C
- About 120 °C
Toon antwoord
Antwoord: C. About 250 °C
Brake parts reach about 120 °C in normal stops and should not exceed about 250 °C.

Gerelateerde examens