CSCS Test Practice (CITB HS&E Operatives) 2026: Test próbny 2

Test próbny 2 z 5 – CSCS Test Practice (CITB HS&E Operatives): kolejne pytania z odpowiedziami i wyjaśnieniami (liczba pytań: 25).

BHP
Wielka Brytania
Pytania: 120
Sprawdzono 10 października 2026

Pytanie 1 z 25
At what daily noise exposure must your employer assess the risk and give you information and training?
- 70 dB(A)
- 100 dB(A)
- 60 dB(A)
- 80 dB(A)
Pokaż odpowiedź
Odpowiedź: D. 80 dB(A)
Under the Control of Noise at Work Regulations 2005, the lower exposure action value is 80 dB(A).
Pytanie 2 z 25
At what daily or weekly noise exposure must your employer provide hearing protection and hearing protection zones?
- 80 dB(A)
- 75 dB(A)
- 95 dB(A)
- 85 dB(A)
Pokaż odpowiedź
Odpowiedź: D. 85 dB(A)
The upper exposure action value is 85 dB(A). Above it, hearing protection and hearing protection zones are required.
Pytanie 3 z 25
What is the noise exposure limit value that must not be exceeded, even with hearing protection taken into account?
- 87 dB(A)
- 90 dB(A)
- 85 dB(A)
- 80 dB(A)
Pokaż odpowiedź
Odpowiedź: A. 87 dB(A)
The exposure limit value is 87 dB(A), and it takes account of the reduction from hearing protection.
Pytanie 4 z 25
You are regularly exposed to noise above 85 dB(A). What must your employer arrange?
- Nothing, if you wear hearing protection
- Health surveillance, such as regular hearing checks
- A free pair of headphones for music
- A pay rise
Pokaż odpowiedź
Odpowiedź: B. Health surveillance, such as regular hearing checks
The Control of Noise at Work Regulations 2005 require health surveillance for workers regularly exposed above 85 dB(A).
Pytanie 5 z 25
Your ears ring after a noisy shift. What could this be a sign of?
- Too much drinking water
- Good hearing
- Damage to your hearing from noise
- A cold coming on
Pokaż odpowiedź
Odpowiedź: C. Damage to your hearing from noise
Ringing in the ears (tinnitus) can be an early sign of hearing damage. Use hearing protection and report it.
Pytanie 6 z 25
Cutting kerbs, blocks or paving with a cut-off saw can produce high levels of which harmful dust?
- Flour dust
- Silica dust
- Pollen
- Sawdust
Pokaż odpowiedź
Odpowiedź: B. Silica dust
HSE warns that cut-off saws on paving, blocks and kerbs can produce very high levels of silica-containing dust.
Pytanie 7 z 25
Which control reduces dust when using a cut-off saw on concrete or stone?
- Cutting faster so the dust has less time to spread
- Working with your back to the wind
- A water attachment connected to a pressurised water supply
- Cutting inside a closed van to trap the dust
Pokaż odpowiedź
Odpowiedź: C. A water attachment connected to a pressurised water supply
Water suppression dampens dust at the point where it is made.
Pytanie 8 z 25
What kind of extraction unit does HSE say to use for on-tool extraction of construction dust?
- Any fan that blows the dust away
- An H class or M class unit
- A household vacuum cleaner
- A leaf blower
Pokaż odpowiedź
Odpowiedź: B. An H class or M class unit
On-tool extraction should use an H or M class extraction unit with the right flow rate and tight hose connections.
Pytanie 9 z 25
Water or extraction is being used, but some silica dust remains. What else is needed?
- Nothing more is needed
- A cloth face covering
- Suitable RPE, such as an FFP3 mask
- A thin paper nuisance dust mask
Pokaż odpowiedź
Odpowiedź: C. Suitable RPE, such as an FFP3 mask
Water does not capture all the silica, so RPE with an assigned protection factor of 20, such as FFP3, is still needed.
Pytanie 10 z 25
Before using a tight-fitting dust mask, what must you have?
- A face-fit test, and you must be clean-shaven where the mask seals
- A short beard to help the edge of the mask seal to your face
- A mask one size bigger than your face so it is comfortable
- A certificate from an optician showing your eyesight is good
Pokaż odpowiedź
Odpowiedź: A. A face-fit test, and you must be clean-shaven where the mask seals
Tight-fitting masks only work if they seal to the face, so users must be clean-shaven and face-fit tested.
Pytanie 11 z 25
What is the best way to reduce dust when you need to split blocks?
- Cut them dry and sweep up the dust afterwards
- Cut several blocks at once to save time
- Use a block splitter instead of a cut-off saw
- Use a bigger and more powerful saw
Pokaż odpowiedź
Odpowiedź: C. Use a block splitter instead of a cut-off saw
HSE says to prevent dust first, for example with lower-energy tools like a block splitter or by having materials cut off site.
Pytanie 12 z 25
Why should you avoid dry sweeping dusty areas on site?
- It puts fine dust back into the air
- It is slower than other methods
- It wears out the brush too quickly
- It leaves the floor too clean and slippery
Pokaż odpowiedź
Odpowiedź: A. It puts fine dust back into the air
Use a suitable vacuum or wet methods instead of dry sweeping to keep harmful dust out of the air.
Pytanie 13 z 25
Which buildings could contain asbestos?
- Only factories and power stations
- Only buildings built after 2000
- Any building built before the year 2000
- Only buildings built before 1950
Pokaż odpowiedź
Odpowiedź: C. Any building built before the year 2000
HSE says asbestos can be found in any building built before the year 2000.
Pytanie 14 z 25
You uncover material you think could be asbestos. What should you do?
- Break off a piece to check it
- Stop work straight away and tell your supervisor
- Sweep it up and put it in a normal skip
- Carry on, but wear a dust mask
Pokaż odpowiedź
Odpowiedź: B. Stop work straight away and tell your supervisor
Do not disturb suspected asbestos. Stop, keep others away and report it so it can be checked.
Pytanie 15 z 25
Which symptoms can be signs of hand-arm vibration syndrome (HAVS)?
- A sore throat, a cough and a runny nose
- Ringing in the ears after a shift
- Tingling, numbness and fingers going white
- Itchy, red and watering eyes
Pokaż odpowiedź
Odpowiedź: C. Tingling, numbness and fingers going white
Regular use of vibrating tools like breakers and grinders can cause HAVS. Report symptoms early.
Pytanie 16 z 25
Leptospirosis (Weil's disease) can be caught from which source on site?
- Loud noise from breakers and saws
- Strong sunlight on bare skin
- Cement dust in the air
- Water or wet ground contaminated by rat urine
Pokaż odpowiedź
Odpowiedź: D. Water or wet ground contaminated by rat urine
Cover cuts, wear gloves and wash your hands before eating, drinking or smoking to reduce the risk.
Pytanie 17 z 25
Wet cement can cause which health problems?
- Skin burns and dermatitis
- Hand-arm vibration syndrome
- Hearing loss
- Broken bones
Pokaż odpowiedź
Odpowiedź: A. Skin burns and dermatitis
Wet cement is alkaline. Wear gloves and suitable clothing, and wash it off your skin quickly.
Pytanie 18 z 25
How can you protect yourself from the sun when working outside?
- Only cover up on cold or cloudy days
- Take your shirt off so your body stays cool
- Keep your top on, wear a hat or neck cover and use sunscreen
- Do nothing; the sun only affects your eyes
Pokaż odpowiedź
Odpowiedź: C. Keep your top on, wear a hat or neck cover and use sunscreen
Ultraviolet light can cause skin cancer. Cover up and check your skin for changes.
Pytanie 19 z 25
What is the first thing to consider when a job involves manual handling?
- Whether the lift can be avoided, for example with a lifting aid
- Who is the strongest and fittest person on the site
- How quickly you can lift it and carry it away
- Whether you can manage to carry it all by yourself
Pokaż odpowiedź
Odpowiedź: A. Whether the lift can be avoided, for example with a lifting aid
The Manual Handling Operations Regulations 1992 say to avoid hazardous manual handling where reasonably practicable, then assess and reduce the risk.
Pytanie 20 z 25
When assessing a lift, which four things should you think about?
- The task, the individual, the load and the environment
- The time, the weather, the cost and the day of the week
- Your age, your height, your shoe size and your pay
- The colour, the size, the price and the brand
Pokaż odpowiedź
Odpowiedź: A. The task, the individual, the load and the environment
The TILE checklist helps you spot what makes a lift risky.
Pytanie 21 z 25
When lifting a load by hand, where should you keep it?
- At arm's length in front of you
- Close to your waist
- Above your head
- Out to one side
Pokaż odpowiedź
Odpowiedź: B. Close to your waist
Keeping the load close to your body reduces strain on your back.
Pytanie 22 z 25
Which three things are needed for a fire to start?
- Heat, fuel and oxygen
- Sparks, metal and plastic
- Smoke, light and noise
- Water, sand and wind
Pokaż odpowiedź
Odpowiedź: A. Heat, fuel and oxygen
Remove any side of the fire triangle and the fire cannot burn.
Pytanie 23 z 25
Which extinguisher is safe to use on a fire in electrical equipment?
- Foam, cream label
- Water, red label
- Carbon dioxide (CO2), black label
- Wet chemical, yellow label
Pokaż odpowiedź
Odpowiedź: C. Carbon dioxide (CO2), black label
CO2 does not conduct electricity. Never use water on an electrical fire.
Pytanie 24 z 25
What is a water extinguisher (red label) suitable for?
- Fires in burning petrol or diesel
- Fires in materials like wood, paper and cloth
- Fires in electrical equipment such as a generator
- Fires in cooking oil or fat in a pan
Pokaż odpowiedź
Odpowiedź: B. Fires in materials like wood, paper and cloth
Water works on solid materials but is dangerous on electrical, flammable liquid and cooking oil fires.
Pytanie 25 z 25
You hear the fire alarm on site. What should you do?
- Stop work, leave by the nearest safe route and go to the assembly point
- Finish the task you are doing first, then leave the site
- Wait at your work area to see if there is any smoke
- Go back to the welfare cabin to collect your belongings
Pokaż odpowiedź
Odpowiedź: A. Stop work, leave by the nearest safe route and go to the assembly point
Leave straight away and report to the assembly point so everyone can be accounted for.

Powiązane testy