CSCS Test Practice (CITB HS&E Operatives) 2026: Übungstest 2

Übungstest 2 von 5 für den Test „CSCS Test Practice (CITB HS&E Operatives)“: 25 weitere Fragen mit Antworten und Erklärungen.

Arbeitsschutz
Vereinigtes Königreich
120 Fragen
Geprüft am 10. Oktober 2026

Frage 1 von 25
At what daily noise exposure must your employer assess the risk and give you information and training?
- 70 dB(A)
- 100 dB(A)
- 60 dB(A)
- 80 dB(A)
Antwort anzeigen
Antwort: D. 80 dB(A)
Under the Control of Noise at Work Regulations 2005, the lower exposure action value is 80 dB(A).
Frage 2 von 25
At what daily or weekly noise exposure must your employer provide hearing protection and hearing protection zones?
- 80 dB(A)
- 75 dB(A)
- 95 dB(A)
- 85 dB(A)
Antwort anzeigen
Antwort: D. 85 dB(A)
The upper exposure action value is 85 dB(A). Above it, hearing protection and hearing protection zones are required.
Frage 3 von 25
What is the noise exposure limit value that must not be exceeded, even with hearing protection taken into account?
- 87 dB(A)
- 90 dB(A)
- 85 dB(A)
- 80 dB(A)
Antwort anzeigen
Antwort: A. 87 dB(A)
The exposure limit value is 87 dB(A), and it takes account of the reduction from hearing protection.
Frage 4 von 25
You are regularly exposed to noise above 85 dB(A). What must your employer arrange?
- Nothing, if you wear hearing protection
- Health surveillance, such as regular hearing checks
- A free pair of headphones for music
- A pay rise
Antwort anzeigen
Antwort: B. Health surveillance, such as regular hearing checks
The Control of Noise at Work Regulations 2005 require health surveillance for workers regularly exposed above 85 dB(A).
Frage 5 von 25
Your ears ring after a noisy shift. What could this be a sign of?
- Too much drinking water
- Good hearing
- Damage to your hearing from noise
- A cold coming on
Antwort anzeigen
Antwort: C. Damage to your hearing from noise
Ringing in the ears (tinnitus) can be an early sign of hearing damage. Use hearing protection and report it.
Frage 6 von 25
Cutting kerbs, blocks or paving with a cut-off saw can produce high levels of which harmful dust?
- Flour dust
- Silica dust
- Pollen
- Sawdust
Antwort anzeigen
Antwort: B. Silica dust
HSE warns that cut-off saws on paving, blocks and kerbs can produce very high levels of silica-containing dust.
Frage 7 von 25
Which control reduces dust when using a cut-off saw on concrete or stone?
- Cutting faster so the dust has less time to spread
- Working with your back to the wind
- A water attachment connected to a pressurised water supply
- Cutting inside a closed van to trap the dust
Antwort anzeigen
Antwort: C. A water attachment connected to a pressurised water supply
Water suppression dampens dust at the point where it is made.
Frage 8 von 25
What kind of extraction unit does HSE say to use for on-tool extraction of construction dust?
- Any fan that blows the dust away
- An H class or M class unit
- A household vacuum cleaner
- A leaf blower
Antwort anzeigen
Antwort: B. An H class or M class unit
On-tool extraction should use an H or M class extraction unit with the right flow rate and tight hose connections.
Frage 9 von 25
Water or extraction is being used, but some silica dust remains. What else is needed?
- Nothing more is needed
- A cloth face covering
- Suitable RPE, such as an FFP3 mask
- A thin paper nuisance dust mask
Antwort anzeigen
Antwort: C. Suitable RPE, such as an FFP3 mask
Water does not capture all the silica, so RPE with an assigned protection factor of 20, such as FFP3, is still needed.
Frage 10 von 25
Before using a tight-fitting dust mask, what must you have?
- A face-fit test, and you must be clean-shaven where the mask seals
- A short beard to help the edge of the mask seal to your face
- A mask one size bigger than your face so it is comfortable
- A certificate from an optician showing your eyesight is good
Antwort anzeigen
Antwort: A. A face-fit test, and you must be clean-shaven where the mask seals
Tight-fitting masks only work if they seal to the face, so users must be clean-shaven and face-fit tested.
Frage 11 von 25
What is the best way to reduce dust when you need to split blocks?
- Cut them dry and sweep up the dust afterwards
- Cut several blocks at once to save time
- Use a block splitter instead of a cut-off saw
- Use a bigger and more powerful saw
Antwort anzeigen
Antwort: C. Use a block splitter instead of a cut-off saw
HSE says to prevent dust first, for example with lower-energy tools like a block splitter or by having materials cut off site.
Frage 12 von 25
Why should you avoid dry sweeping dusty areas on site?
- It puts fine dust back into the air
- It is slower than other methods
- It wears out the brush too quickly
- It leaves the floor too clean and slippery
Antwort anzeigen
Antwort: A. It puts fine dust back into the air
Use a suitable vacuum or wet methods instead of dry sweeping to keep harmful dust out of the air.
Frage 13 von 25
Which buildings could contain asbestos?
- Only factories and power stations
- Only buildings built after 2000
- Any building built before the year 2000
- Only buildings built before 1950
Antwort anzeigen
Antwort: C. Any building built before the year 2000
HSE says asbestos can be found in any building built before the year 2000.
Frage 14 von 25
You uncover material you think could be asbestos. What should you do?
- Break off a piece to check it
- Stop work straight away and tell your supervisor
- Sweep it up and put it in a normal skip
- Carry on, but wear a dust mask
Antwort anzeigen
Antwort: B. Stop work straight away and tell your supervisor
Do not disturb suspected asbestos. Stop, keep others away and report it so it can be checked.
Frage 15 von 25
Which symptoms can be signs of hand-arm vibration syndrome (HAVS)?
- A sore throat, a cough and a runny nose
- Ringing in the ears after a shift
- Tingling, numbness and fingers going white
- Itchy, red and watering eyes
Antwort anzeigen
Antwort: C. Tingling, numbness and fingers going white
Regular use of vibrating tools like breakers and grinders can cause HAVS. Report symptoms early.
Frage 16 von 25
Leptospirosis (Weil's disease) can be caught from which source on site?
- Loud noise from breakers and saws
- Strong sunlight on bare skin
- Cement dust in the air
- Water or wet ground contaminated by rat urine
Antwort anzeigen
Antwort: D. Water or wet ground contaminated by rat urine
Cover cuts, wear gloves and wash your hands before eating, drinking or smoking to reduce the risk.
Frage 17 von 25
Wet cement can cause which health problems?
- Skin burns and dermatitis
- Hand-arm vibration syndrome
- Hearing loss
- Broken bones
Antwort anzeigen
Antwort: A. Skin burns and dermatitis
Wet cement is alkaline. Wear gloves and suitable clothing, and wash it off your skin quickly.
Frage 18 von 25
How can you protect yourself from the sun when working outside?
- Only cover up on cold or cloudy days
- Take your shirt off so your body stays cool
- Keep your top on, wear a hat or neck cover and use sunscreen
- Do nothing; the sun only affects your eyes
Antwort anzeigen
Antwort: C. Keep your top on, wear a hat or neck cover and use sunscreen
Ultraviolet light can cause skin cancer. Cover up and check your skin for changes.
Frage 19 von 25
What is the first thing to consider when a job involves manual handling?
- Whether the lift can be avoided, for example with a lifting aid
- Who is the strongest and fittest person on the site
- How quickly you can lift it and carry it away
- Whether you can manage to carry it all by yourself
Antwort anzeigen
Antwort: A. Whether the lift can be avoided, for example with a lifting aid
The Manual Handling Operations Regulations 1992 say to avoid hazardous manual handling where reasonably practicable, then assess and reduce the risk.
Frage 20 von 25
When assessing a lift, which four things should you think about?
- The task, the individual, the load and the environment
- The time, the weather, the cost and the day of the week
- Your age, your height, your shoe size and your pay
- The colour, the size, the price and the brand
Antwort anzeigen
Antwort: A. The task, the individual, the load and the environment
The TILE checklist helps you spot what makes a lift risky.
Frage 21 von 25
When lifting a load by hand, where should you keep it?
- At arm's length in front of you
- Close to your waist
- Above your head
- Out to one side
Antwort anzeigen
Antwort: B. Close to your waist
Keeping the load close to your body reduces strain on your back.
Frage 22 von 25
Which three things are needed for a fire to start?
- Heat, fuel and oxygen
- Sparks, metal and plastic
- Smoke, light and noise
- Water, sand and wind
Antwort anzeigen
Antwort: A. Heat, fuel and oxygen
Remove any side of the fire triangle and the fire cannot burn.
Frage 23 von 25
Which extinguisher is safe to use on a fire in electrical equipment?
- Foam, cream label
- Water, red label
- Carbon dioxide (CO2), black label
- Wet chemical, yellow label
Antwort anzeigen
Antwort: C. Carbon dioxide (CO2), black label
CO2 does not conduct electricity. Never use water on an electrical fire.
Frage 24 von 25
What is a water extinguisher (red label) suitable for?
- Fires in burning petrol or diesel
- Fires in materials like wood, paper and cloth
- Fires in electrical equipment such as a generator
- Fires in cooking oil or fat in a pan
Antwort anzeigen
Antwort: B. Fires in materials like wood, paper and cloth
Water works on solid materials but is dangerous on electrical, flammable liquid and cooking oil fires.
Frage 25 von 25
You hear the fire alarm on site. What should you do?
- Stop work, leave by the nearest safe route and go to the assembly point
- Finish the task you are doing first, then leave the site
- Wait at your work area to see if there is any smoke
- Go back to the welfare cabin to collect your belongings
Antwort anzeigen
Antwort: A. Stop work, leave by the nearest safe route and go to the assembly point
Leave straight away and report to the assembly point so everyone can be accounted for.

Ähnliche Tests