OSHA 10 Construction Practice Test 2026: Übungstest 2

Übungstest 2 von 3 für den Test „OSHA 10 Construction Practice Test“: 25 weitere Fragen mit Antworten und Erklärungen.

  • Arbeitsschutz
  • Vereinigte Staaten
  • 80 Fragen
  • Geprüft am 10. Oktober 2026
  1. Frage 1 von 25

    At what height must workers on a scaffold be protected from falls?
    Antwort anzeigen

    Antwort: B. More than 10 feet above a lower level

    Under 1926.451(g)(1), fall protection is required on scaffolds more than 10 feet above a lower level.

  2. Frage 2 von 25

    When must a competent person inspect a scaffold for visible defects?
    Antwort anzeigen

    Antwort: C. Before each work shift

    Scaffolds and their components must be inspected by a competent person before each shift and after any occurrence that could affect structural integrity.

  3. Frage 3 von 25

    How much load must a scaffold be able to support?
    Antwort anzeigen

    Antwort: A. Its own weight and 4 times the maximum intended load

    Each scaffold and component must support its own weight and at least 4 times the maximum intended load.

  4. Frage 4 von 25

    Who may erect, move or dismantle a scaffold?
    Antwort anzeigen

    Antwort: B. Trained workers supervised by a competent person

    Scaffolds must be erected, moved, dismantled or altered only under the supervision and direction of a competent person.

  5. Frage 5 von 25

    Can you use concrete blocks or loose bricks to support a scaffold?
    Antwort anzeigen

    Antwort: D. No, unstable objects must not be used

    Scaffolds need firm footing, such as base plates and mud sills. Unstable objects like loose bricks can crumble.

  6. Frage 6 von 25

    A portable ladder is used to reach an upper landing. How far must its side rails extend above the landing?
    Antwort anzeigen

    Antwort: A. At least 3 feet

    Under 1926.1053(b)(1), side rails must extend at least 3 feet above the upper landing surface.

  7. Frage 7 von 25

    At what angle should a non-self-supporting ladder be set?
    Antwort anzeigen

    Antwort: B. About 1/4 of the working length out from the wall (4 to 1)

    The horizontal distance from the top support to the foot should be about one-quarter of the working length.

  8. Frage 8 von 25

    Can you stand on the top step of a stepladder?
    Antwort anzeigen

    Antwort: B. No, the top or top step must not be used as a step

    OSHA forbids using the top or top step of a stepladder as a step.

  9. Frage 9 von 25

    How should you face when climbing up or down a ladder?
    Antwort anzeigen

    Antwort: C. Toward the ladder

    When going up or down a ladder, the user must face the ladder.

  10. Frage 10 von 25

    How many hands must you use to grasp the ladder while climbing?
    Antwort anzeigen

    Antwort: C. At least one

    Each worker must use at least one hand to grasp the ladder when moving up or down. Do not carry loads that could make you lose balance.

  11. Frage 11 von 25

    What must happen to a ladder with a broken rung?
    Antwort anzeigen

    Antwort: A. Tag it "Do Not Use" and take it out of service

    Defective ladders must be tagged or marked and withdrawn from service until repaired.

  12. Frage 12 von 25

    What kind of ladder must you use where you could contact exposed energized electrical equipment?
    Antwort anzeigen

    Antwort: D. One with nonconductive side rails

    Ladders must have nonconductive side rails if the worker or ladder could contact exposed energized electrical equipment.

  13. Frage 13 von 25

    At what break in elevation must a stairway or ladder be provided at access points?
    Antwort anzeigen

    Antwort: C. 19 inches or more

    Under 1926.1051(a), a stairway or ladder is required at points of access where there is a break in elevation of 19 inches or more.

  14. Frage 14 von 25

    What does a ground-fault circuit interrupter (GFCI) do?
    Antwort anzeigen

    Antwort: C. It cuts power fast when current leaks to ground

    GFCIs detect ground faults and cut power fast. 1926.404(b)(1) requires GFCIs or an assured equipment grounding conductor program on construction sites.

  15. Frage 15 von 25

    You find an extension cord with cracked insulation. What should you do?
    Antwort anzeigen

    Antwort: C. Remove it from service and report it

    Damaged cords can expose live wires. Take them out of service until repaired or replaced.

  16. Frage 16 von 25

    How should you treat overhead power lines on a job site?
    Antwort anzeigen

    Antwort: D. Assume they are energized and keep a safe distance

    Contact with overhead lines is a leading cause of electrocution. Always assume lines are live.

  17. Frage 17 von 25

    Under OSHA's crane rules, what is the minimum clearance from power lines up to 50 kV?
    Antwort anzeigen

    Antwort: C. 10 feet

    Table A of 1926.1408 lists a 10-foot minimum clearance for voltages up to 50 kV. Higher voltages need more distance.

  18. Frage 18 von 25

    Before working on electrical equipment, what must be done?
    Antwort anzeigen

    Antwort: C. The circuit must be de-energized and locked or tagged out

    Locking out and tagging the circuit stops someone from switching it on while you work.

  19. Frage 19 von 25

    Why is using electric tools in wet conditions dangerous?
    Antwort anzeigen

    Antwort: A. Water makes it easier for current to flow through your body

    Wet conditions raise the risk of shock. Use GFCI protection and tools rated for the conditions.

  20. Frage 20 von 25

    What should you wear when working near moving vehicles or traffic?
    Antwort anzeigen

    Antwort: C. High-visibility clothing, such as a vest

    High-visibility garments help drivers and operators see you.

  21. Frage 21 von 25

    A crane is lifting a load. Where should you never stand?
    Antwort anzeigen

    Antwort: B. Under the suspended load

    Loads can slip or fall. Stay out from under suspended loads and outside barricaded swing areas.

  22. Frage 22 von 25

    A vehicle on site has an obstructed view to the rear. What must it have before backing up?
    Antwort anzeigen

    Antwort: B. A working reverse alarm, or an observer

    Under 1926.601(b)(4), vehicles with an obstructed rear view need a reverse alarm audible above surrounding noise, or an observer.

  23. Frage 23 von 25

    How can you keep tools and materials from falling on workers below?
    Antwort anzeigen

    Antwort: C. Use toeboards, screens or tool lanyards, and keep materials away from edges

    Falling objects are a major struck-by hazard. Prevent them falling and protect people below.

  24. Frage 24 von 25

    When must workers wear hard hats?
    Antwort anzeigen

    Antwort: A. When there is a danger of head injury

    Under 1926.100(a), protective helmets are required wherever there is a possible danger of head injury.

  25. Frage 25 von 25

    When is eye or face protection required?
    Antwort anzeigen

    Antwort: A. When flying particles or chemicals could injure the eyes or face

    Under 1926.102, employers must provide eye and face protection when operations present a potential eye or face injury.

Ähnliche Tests