PassEveryTest
Polski

Northwest Territories Traffic Control Course 2026

This course is for security guards and other workers in the Northwest Territories who may be asked to help with traffic control. It covers the territory's rules for designated signallers, the WSCC code of practice, equipment, set-up and signals. It is background knowledge only and does not replace the site-specific training and TCP training card your employer must provide.

  • Kurs
  • Terytoria Północno-Zachodnie
  • Pytania: 25
  • Sprawdzono 12 października 2026

W skrócie

Ten bezpłatny kurs obejmuje około 30 minut lekcji i test z 25 pytaniami. Uzyskaj co najmniej 80%, aby pobrać zaświadczenie o ukończeniu (prywatne, nieakredytowane). Sprawdzono z oficjalnymi źródłami 12 października 2026.

Zacznij od lekcjiNorthwest Territories Traffic Control Course: Lessons: ok. 30 min czytania. Każde pytanie testowe jest omówione w lekcjach.

Czego się nauczysz

  • Explain who may act as a traffic control person in the NWT and what training the employer must give
  • Describe what a traffic control plan contains and when signallers may be used
  • Choose the right hi-vis apparel, paddle and night equipment
  • Set up a safe control position and escape route
  • Give clear stop, slow and release signals and handle a radio failure

Uzyskaj co najmniej 80%, aby pobrać certyfikat.

  1. Pytanie 1 z 25

    What do the NWT Occupational Health and Safety Regulations call a worker the employer names to direct traffic or equipment?
    Pokaż odpowiedź

    Odpowiedź: D. A designated signaller

    Section 138 of the NWT regulations uses the term designated signaller. On the job, this person is often called a traffic control person (TCP) or flagger.

  2. Pytanie 2 z 25

    Under section 138, who must train a designated signaller and keep a record of the training?
    Pokaż odpowiedź

    Odpowiedź: A. The employer

    Section 138(1) requires the employer to designate and train the signaller, keep a record of the training and give the signaller a copy.

  3. Pytanie 3 z 25

    What must a TCP in the NWT carry on the job and show to authorities when asked?
    Pokaż odpowiedź

    Odpowiedź: D. A TCP card signed by the trainer or employer

    The WSCC code says a TCP must have a training card signed by the trainer or employer, carry it on the job and show it when asked.

  4. Pytanie 4 z 25

    How long is the NWT and Nunavut TCP training card valid?
    Pokaż odpowiedź

    Odpowiedź: B. One year

    The WSCC code of practice states that the TCP training card is valid for one year, with refresher training each year or as required.

  5. Pytanie 5 z 25

    You already have general TCP training and you start at a new job location. What does WSCC guidance say you also need?
    Pokaż odpowiedź

    Odpowiedź: C. Site-specific training for that job location

    WSCC's TCP training guideline says additional site-specific training has to be provided for every job location.

  6. Pytanie 6 z 25

    What is the legal status of the WSCC Traffic Control Person Code of Practice?
    Pokaż odpowiedź

    Odpowiedź: D. Not following it may count against compliance

    Codes of practice made under the Safety Act are guidance. Failure to follow one may be considered in deciding compliance with the Act and regulations.

  7. Pytanie 7 z 25

    Under section 139(4), when may an employer use designated signallers to control traffic on a highway?
    Pokaż odpowiedź

    Odpowiedź: A. Only when other methods are not enough

    Section 139(4) says signallers must not be used on a highway unless the other listed methods of traffic control are inadequate or unsuitable.

  8. Pytanie 8 z 25

    Traffic comes from both directions and the signaller and drivers cannot clearly see each other. Under section 139(5), how many signallers are needed?
    Pokaż odpowiedź

    Odpowiedź: B. Two

    Section 139(5) allows one signaller when traffic comes from one direction or the signaller and drivers can see each other, and requires two when they cannot.

  9. Pytanie 9 z 25

    Under section 139, what must the employer develop when workers are at risk from vehicle traffic?
    Pokaż odpowiedź

    Odpowiedź: A. A written traffic control plan

    Section 139 requires a written traffic control plan, training for workers in the plan, and that the plan be readily available at the site.

  10. Pytanie 10 z 25

    According to WSCC's TCP safety bulletin, what must each TCP do with the traffic control plan for the shift?
    Pokaż odpowiedź

    Odpowiedź: A. Know it and sign it

    The bulletin says TCPs must know and sign the shift's traffic control plan, and the supervisor keeps it on site.

  11. Pytanie 11 z 25

    How tall must the stop/slow sign be under the WSCC code of practice?
    Pokaż odpowiedź

    Odpowiedź: C. At least 1.6 metres

    The WSCC TCP code of practice says the sign has to be at least 1.6 metres tall, with reflective sheeting on both sides.

  12. Pytanie 12 z 25

    What colours are used on the SLOW side of the paddle in the NWT code?
    Pokaż odpowiedź

    Odpowiedź: D. Black letters on a yellow background

    The code says SLOW is black on yellow and STOP is white on red, and both sides must be reflective.

  13. Pytanie 13 z 25

    Which standard does WSCC's high-visibility code of practice use for hi-vis apparel?
    Pokaż odpowiedź

    Odpowiedź: B. CSA Z96

    The WSCC PPE High Visibility Apparel code of practice is based on CSA Z96, High-Visibility Safety Apparel.

  14. Pytanie 14 z 25

    WSCC lists flagging crews as high risk. Which class of hi-vis apparel does it point to for low light or night work?
    Pokaż odpowiedź

    Odpowiedź: D. Class 3

    For high-risk work such as flagging, the WSCC code points to Class 2 in daytime and Class 3 in low light.

  15. Pytanie 15 z 25

    Where does the WSCC code say a TCP should stand?
    Pokaż odpowiedź

    Odpowiedź: B. Halfway between the last sign and the taper

    The code places the control position halfway between the last sign and the taper, just outside the travel lane, with the paddle on the edge line.

  16. Pytanie 16 z 25

    The WSCC code says you should not set up your control position in which of these places?
    Pokaż odpowiedź

    Odpowiedź: A. On a bridge

    The code says not to flag on a bridge, near a railway crossing, over a hill, around a curve or on icy roads.

  17. Pytanie 17 z 25

    When should the "TCP ahead" sign be displayed?
    Pokaż odpowiedź

    Odpowiedź: D. Only when TCPs are actively controlling traffic

    The code says the TCP sign is used only when TCPs are actively regulating traffic. Unless mounted high, it shows two red-orange flags.

  18. Pytanie 18 z 25

    How often does the WSCC code say a TCP should be rotated from the control position?
    Pokaż odpowiedź

    Odpowiedź: D. Every two hours, or as the supervisor arranges

    The code says a TCP should be rotated every two hours, or as arranged with the supervisor.

  19. Pytanie 19 z 25

    On dry, level pavement, about how far does a vehicle at 100 km/h need to stop, according to the WSCC code?
    Pokaż odpowiedź

    Odpowiedź: C. 210 metres

    The code gives 210 m (about 42 car lengths) at 100 km/h and 65 m at 50 km/h, and more for trucks, wet or icy roads and downhill traffic.

  20. Pytanie 20 z 25

    How do you release stopped traffic under the WSCC code?
    Pokaż odpowiedź

    Odpowiedź: C. Turn the paddle to SLOW and wave drivers on with your arm

    The code says to turn the paddle to SLOW and then signal with the free arm. It says never to wave the sign.

  21. Pytanie 21 z 25

    What is the emergency hand signal between partner TCPs in the WSCC code?
    Pokaż odpowiedź

    Odpowiedź: A. Drop the paddle and wave both arms above your head

    The code's emergency signal is to drop the paddle, raise both arms and wave them above the head.

  22. Pytanie 22 z 25

    Your radio stops working while you are showing STOP. What does the WSCC code say to do with your sign?
    Pokaż odpowiedź

    Odpowiedź: B. Keep it as it is and repeat the message

    The code says not to change signs when a radio fails. Repeat the message and check the radio; if it has failed, the TCP showing SLOW stops a vehicle and asks the driver to report the failure to a person in authority.

  23. Pytanie 23 z 25

    Which item does the WSCC code list as mandatory for TCPs working at night?
    Pokaż odpowiedź

    Odpowiedź: A. A flashlight with a red or orange cone

    For night work the code requires a flashlight with a red or orange cone, reflective material around the hard hat and reflective stripes on clothing. Section 138 also requires a suitable light in darkness.

  24. Pytanie 24 z 25

    What does the NWT Driver's Manual say about speeding fines in construction zones when workers are present?
    Pokaż odpowiedź

    Odpowiedź: D. Fines for speeding are doubled

    The NWT Driver's Manual says speeding fines are doubled in construction zones if workers are present, and tells drivers to obey the flag person.

  25. Pytanie 25 z 25

    A police officer arrives and starts directing traffic at your work zone. According to the NWT Driver's Manual, whose directions do drivers follow?
    Pokaż odpowiedź

    Odpowiedź: B. The officer's, since police overrule signs

    The Driver's Manual says directions given by a police officer overrule traffic signs or signals. Follow the officer's lead and coordinate with them.

Co warto wiedzieć przed egzaminem

  • Section 138 of the NWT Occupational Health and Safety Regulations makes the employer designate, train and keep training records for each designated signaller.
  • The NWT and Nunavut TCP training card is signed by the trainer or employer, must be carried on the job and is valid for one year.
  • Signallers may control traffic on a highway only when signs, barriers, flashing lights, pilot vehicles and other methods are inadequate or unsuitable.
  • The WSCC code calls for a stop/slow sign at least 1.6 metres tall: STOP white on red, SLOW black on yellow, reflective on both sides.
  • The NWT Driver's Manual tells drivers to obey the flag person and says speeding fines double in construction zones when workers are present.

Najczęściej zadawane pytania

Do I need a certificate to be a traffic control person in the NWT?

The NWT regulations require your employer to designate you, train you and keep a record of the training. The WSCC code calls for a TCP training card signed by the trainer or employer, valid for one year, plus site-specific training for each job. This course does not give you that card.

Who enforces traffic control safety rules in the NWT?

The Workers' Safety and Compensation Commission (WSCC) enforces the Safety Act and the Occupational Health and Safety Regulations in the NWT. Its safety officers can inspect work sites.

Can a security guard direct traffic on a public road in the NWT?

Only as a designated, trained signaller working under a written traffic control plan, and only where other methods of traffic control are not enough. Police directions overrule signs and signals.

What should a TCP wear at night in the NWT?

High-visibility apparel to CSA Z96 (WSCC points to Class 3 for flaggers in low light), reflective material around the hard hat, and a flashlight with a red or orange cone.

Czy zaświadczenie jest akredytowane lub oficjalnie uznawane?

Nie. To prywatne zaświadczenie o ukończeniu, wyłącznie dla Twojej wiedzy. Nie jest uznawane, akredytowane ani zatwierdzone przez żaden rząd, organ licencyjny, regulatora ani instytucję edukacyjną i nie zastępuje żadnej licencji, certyfikacji ani szkolenia wymaganych przez prawo.

Źródła

Powiązane testy