Queensland Heavy Vehicle Road Rules Test Practice 2026: Practice test 2

Practice test 2 ng 3 para sa Queensland Heavy Vehicle Road Rules Test Practice: 25 pang tanong na may mga sagot at paliwanag.

Komersyal na sasakyan
Queensland
90 tanong
Sinuri noong Oktubre 11, 2026

Tanong 1 ng 25
Under standard hours, what is the most a solo truck driver may work in any 11 hours?
- 10 hours
- 11 hours
- 9 hours
- 10 hours 45 minutes
Ipakita ang sagot
Sagot: A. 10 hours
In any 11 hours you may work up to 10 hours and must rest for at least 60 minutes, in blocks of 15 minutes or more.
Tanong 2 ng 25
What is the minimum tyre tread depth on a heavy vehicle?
- 5 mm
- 3 mm across the whole tyre
- 1.5 mm over 75% of the surface that touches the road
- 0.5 mm
Ipakita ang sagot
Sagot: C. 1.5 mm over 75% of the surface that touches the road
Tyres must have at least 1.5 mm of tread over 75% of the part of the tyre that contacts the road.
Tanong 3 ng 25
May you use the trailer hand brake for normal braking?
- Only on downhill grades
- Yes, it saves the prime mover's brakes
- No, it must not be used for normal braking
- Only on wet roads
Ipakita ang sagot
Sagot: C. No, it must not be used for normal braking
The trailer hand brake is not for normal braking. Overusing it can overheat the trailer brakes and cause a jack-knife.
Tanong 4 ng 25
Your air tanks should always hold enough pressure for how many brake applications?
- At least twenty
- At least one
- At least five
- Exactly two
Ipakita ang sagot
Sagot: C. At least five
Keep enough air for at least five brake applications so you can always stop safely.
Tanong 5 ng 25
Which method restrains a load by carrying it inside a solid-sided body, tanker or shipping container?
- Lashing
- Cross bearing
- Containment
- Sheeting
Ipakita ang sagot
Sagot: C. Containment
Containment holds the load inside the body of the vehicle or a container. Other methods include lashing, blocking and sheeting loose loads.
Tanong 6 ng 25
Which vehicles may display a 'Do not overtake turning vehicle' sign?
- Vehicles 7.5 metres or longer
- Only buses
- Any vehicle over 4.5 tonnes GVM
- Any truck
Ipakita ang sagot
Sagot: A. Vehicles 7.5 metres or longer
Only vehicles 7.5 metres or longer may display the sign. Shorter vehicles must turn within the marked lanes.
Tanong 7 ng 25
Where there are two right-turn lanes, which lane should a long vehicle use?
- The far-left of the two right-turn lanes
- Either lane
- The far-right lane
- The left lane of the road
Ipakita ang sagot
Sagot: A. The far-left of the two right-turn lanes
Using the left of the two right-turn lanes gives the trailer room as it tracks inside.
Tanong 8 ng 25
Why does a long truck swing wide when turning left at an intersection?
- To let cars pass on the left
- To stop the rear wheels running over the kerb or hitting objects
- To slow down traffic behind
- Because heavy vehicles must use the right lane
Ipakita ang sagot
Sagot: B. To stop the rear wheels running over the kerb or hitting objects
The rear wheels track inside the front wheels. Going further into the intersection before turning stops them mounting the kerb.
Tanong 9 ng 25
A bridge sign shows a gross load limit of 20 t. Your vehicle and load weigh 20 t. What should you do?
- Cross if no other vehicle is on the bridge
- Do not cross; find another route
- Cross in the middle of the bridge
- Cross slowly
Ipakita ang sagot
Sagot: B. Do not cross; find another route
You must not pass a load limit sign if your gross mass equals or exceeds the limit shown.
Tanong 10 ng 25
Under standard hours for a solo truck driver, what is the most work allowed in any 24-hour period?
- 15½ hours
- 12 hours
- 10 hours
- 14 hours
Ipakita ang sagot
Sagot: B. 12 hours
Standard hours allow a maximum of 12 hours work in any 24 hours.
Tanong 11 ng 25
Up to what length may a B-double run under the applicable notice or approval?
- 53.5 metres
- 19 metres
- 22 metres
- 26 metres
Ipakita ang sagot
Sagot: D. 26 metres
A B-double that meets the conditions may be up to 26 metres long. Combinations over 22 metres must display a sign.
Tanong 12 ng 25
What is the general maximum height for a heavy vehicle and its load?
- 3.5 metres
- 5 metres
- 4.3 metres
- 6 metres
Ipakita ang sagot
Sagot: C. 4.3 metres
The general height limit is 4.3 metres. Some vehicles may go up to 4.6 metres only under a notice or permit on approved routes.
Tanong 13 ng 25
What is the general maximum width of a heavy vehicle and its load?
- 3 metres
- 2.2 metres
- 3.5 metres
- 2.5 metres
Ipakita ang sagot
Sagot: D. 2.5 metres
The general width limit is 2.5 metres. Mirrors, signalling devices and tyre pressure monitors are not counted.
Tanong 14 ng 25
Which bus is a fatigue-regulated heavy vehicle?
- Any bus with more than 8 seats
- Only a school bus
- Only a double-decker bus
- A bus over 4.5 tonnes GVM built to seat more than 12 adults, including the driver
Ipakita ang sagot
Sagot: D. A bus over 4.5 tonnes GVM built to seat more than 12 adults, including the driver
A bus is fatigue-regulated when it has a GVM over 4.5 tonnes and seats more than 12 adults including the driver.
Tanong 15 ng 25
What is the general maximum length of an articulated vehicle such as a prime mover and semi-trailer?
- 19 metres
- 36.5 metres
- 26 metres
- 12.5 metres
Ipakita ang sagot
Sagot: A. 19 metres
The general limit for a combination is 19 metres. Longer vehicles, such as B-doubles, need approved routes.
Tanong 16 ng 25
A load restraint system must be able to hold the load against a sideways force of what share of the load's weight?
- 80%
- 50%
- 10%
- 20%
Ipakita ang sagot
Sagot: B. 50%
Sideways and rearward forces of 50% of the load's weight must be resisted. Forward it is 80%, and upward 20%.
Tanong 17 ng 25
Why can an engine brake or exhaust brake be dangerous on a slippery road?
- It is too noisy
- It stops the air compressor
- It uses too much fuel
- It may make a lightly loaded vehicle skid or jack-knife
Ipakita ang sagot
Sagot: D. It may make a lightly loaded vehicle skid or jack-knife
Engine and exhaust brakes act only on the drive wheels. On a slippery surface they can lock those wheels, especially on a lightly loaded vehicle.
Tanong 18 ng 25
How often should a heavy vehicle driver check the vehicle?
- Only when a warning light comes on
- Only at the yearly inspection
- Once a month
- A pre-departure check every day, plus a more detailed inspection each week
Ipakita ang sagot
Sagot: D. A pre-departure check every day, plus a more detailed inspection each week
Do a walk-around check before every trip and a more thorough inspection weekly.
Tanong 19 ng 25
How many warning triangles must a vehicle over 12 tonnes GVM carry?
- Three
- Two
- None
- One
Ipakita ang sagot
Sagot: A. Three
Vehicles over 12 tonnes GVM must carry three warning triangles to use if the vehicle or its load stops on the road.
Tanong 20 ng 25
How far may a load stick out from each side of a heavy vehicle?
- No more than 1 metre from each side
- No more than 500 mm from each side
- No more than 150 mm from each side, and the total width must stay within 2.5 metres
- Any amount if the load is light
Ipakita ang sagot
Sagot: C. No more than 150 mm from each side, and the total width must stay within 2.5 metres
A load may project no more than 150 mm from each side, and the overall width with the load must not exceed 2.5 metres.
Tanong 21 ng 25
What should you do if your truck gets stuck on a railway level crossing?
- Get out, move to a safe place and call triple zero (000)
- Try to push the truck off
- Wait for the train driver to stop
- Stay in the cabin and sound the horn
Ipakita ang sagot
Sagot: A. Get out, move to a safe place and call triple zero (000)
Your safety comes first. Leave the vehicle, move well away from the tracks and call 000.
Tanong 22 ng 25
Your truck breaks down on a divided road. Where should the warning triangles go?
- One in front and two beside
- One beside the vehicle and two behind it
- None are needed on divided roads
- All three in front
Ipakita ang sagot
Sagot: B. One beside the vehicle and two behind it
On a divided or one-way road, all traffic comes from behind, so put one triangle beside the vehicle and two behind it.
Tanong 23 ng 25
Which regulation sets the maximum work and minimum rest times for drivers of fatigue-regulated heavy vehicles?
- The Load Restraint Guide
- The Australian Design Rules
- Each employer's own policy
- The Heavy Vehicle (Fatigue Management) National Regulation
Ipakita ang sagot
Sagot: D. The Heavy Vehicle (Fatigue Management) National Regulation
Work and rest limits come from the Heavy Vehicle (Fatigue Management) National Regulation under the Heavy Vehicle National Law.
Tanong 24 ng 25
In a built-up area, how long may a heavy vehicle (other than a bus) stay stopped on a road?
- There is no limit
- Up to 24 hours
- Up to 4 hours
- No more than 1 hour
Ipakita ang sagot
Sagot: D. No more than 1 hour
Unless a sign allows longer, a heavy vehicle may not stop on a road in a built-up area for more than one hour. Buses are exempt.
Tanong 25 ng 25
Under the chain of responsibility, who must take all reasonable steps to prevent driver fatigue and speeding?
- Only the police and the regulator
- Every party in the supply chain, such as employers, operators, schedulers, consignors, consignees and loaders
- Only the driver
- Only the owner of the truck
Ipakita ang sagot
Sagot: B. Every party in the supply chain, such as employers, operators, schedulers, consignors, consignees and loaders
The Heavy Vehicle National Law puts safety duties on everyone in the chain who controls or influences transport, not just the driver.

Mga kaugnay na pagsusulit