Transportation of Dangerous Goods (TDG) Road Course: Labels, placards and UN number marks
Prueba temática sin límite de tiempo: 17 preguntas sobre Labels, placards and UN number marks, con una explicación después de cada respuesta. Las preguntas y respuestas se mezclan cada vez.
Prueba temática 3: Labels, placards and UN number marks
-
Pregunta 1 de 17
Ver respuesta
Respuesta: C. Small ones, of 450 L or less
Labels generally go on small means of containment (450 L or less); placards go on large ones (over 450 L).
-
Pregunta 2 de 17
Ver respuesta
Respuesta: A. 250 mm
Section 4.8: each side of a placard must be at least 250 mm. 100 mm is the label size.
-
Pregunta 3 de 17
Ver respuesta
Respuesta: D. 100 mm
Section 4.7: each side of a label must be at least 100 mm; it may be reduced to no less than 30 mm only when needed.
-
Pregunta 4 de 17
Ver respuesta
Respuesta: A. On each side and each end
Section 4.15: the primary class placard must be on each side and each end of a large means of containment.
-
Pregunta 5 de 17
Ver respuesta
Respuesta: C. The consignor
Section 4.4: the consignor must display, or ensure the display of, the required marks on each small means of containment.
-
Pregunta 6 de 17
Ver respuesta
Respuesta: B. The carrier, using the consignor's placards
Section 4.5: the carrier must display the required marks on a large means of containment unless they are already displayed; the consignor must provide them.
-
Pregunta 7 de 17
Ver respuesta
Respuesta: D. No, it must be square on point, like a diamond
Section 4.8 requires a placard to be displayed square on point, like a diamond, when the means of containment is upright.
-
Pregunta 8 de 17
Ver respuesta
Respuesta: A. At least 65 mm
Section 4.15.2: on a large means of containment the UN number is shown without "UN" in black digits at least 65 mm high, on an orange panel or in a white rectangle on the placard. 12 mm is for most small containers.
-
Pregunta 9 de 17
Ver respuesta
Respuesta: D. If an ERAP is needed or a liquid or gas touches the tank
Section 4.15.2(1) requires the UN number for goods needing an ERAP, or liquids or gases in direct contact with the container.
-
Pregunta 10 de 17
Ver respuesta
Respuesta: A. They must be removed or covered, as they are misleading
Section 4.2 forbids misleading marks, and section 4.9 requires marks to be covered or removed when the danger is no longer present.
-
Pregunta 11 de 17
Ver respuesta
Respuesta: B. Keep them, because residue is still regulated
Transport Canada says placards and UN numbers are required even for residue liquids or gases, until the tank is cleaned and purged.
-
Pregunta 12 de 17
Ver respuesta
Respuesta: C. No, not at 500 kg or less, but it may still be shown
Under the 500 kg exemption (section 4.16.1), placards are not required for 500 kg gross mass or less; Transport Canada uses this acetone example.
-
Pregunta 13 de 17
Ver respuesta
Respuesta: D. Yes, 540 kg is over the 500 kg limit
4 × 135 kg = 540 kg gross mass. That is more than 500 kg, so the 500 kg exemption cannot be used.
-
Pregunta 14 de 17
Ver respuesta
Respuesta: D. The gross mass: containers plus contents
Section 4.16.1 uses gross mass, and Transport Canada says the mass of the means of containment counts toward it.
-
Pregunta 15 de 17
Ver respuesta
Respuesta: B. No, Class 2.3 is excluded from it
Section 4.16.1(2) excludes goods such as Class 2.3, Class 4.3, ERAP goods and goods needing a subsidiary placard.
-
Pregunta 16 de 17
Ver respuesta
Respuesta: A. Mixed goods needing different placards, in small containers
Section 4.16 allows the optional DANGER placard only in that case, and never for goods such as Class 1, 2.3 or 4.3.
-
Pregunta 17 de 17
Ver respuesta
Respuesta: D. A Class 3 placard and only UN1203 (lowest flash point)
For compartments with the same class, Transport Canada's example is a Class 3 placard with only UN1203, because gasoline has the lowest flash point.
Teclado: 1–4 para responder, Intro para la siguiente pregunta.